In the processing of cables in various industrial equipment, electronic appliances, etc., computer < strong="">The role of the cutting machine is very obvious. It not only breaks through the traditional manual processing, but also saves more resources and reduces the consumption of manpower and material resources. It is a very practical wire harness processing equipment. Understanding the operation steps of the computer cutting machine is also very helpful for the major wire harness manufacturers. The correct operation steps can make the machine more safe to produce, and can also effectively reduce some unnecessary machine failures. Let's let Xiaobian give us a detailed explanation of the operating steps of the computer cutting machine!

 The computer cutting machine first needs to know whether the parts of the machine are damaged, whether the power voltage can be supplied, and whether there is any blockage between the ruler and the gear before starting the computer cutting machine; After the inspection is completed, start the cutting machine. After a small operation, open the wire cylinder of the cutting machine, carefully place the wire harness in the guide wheel of the cutting machine to carry the wheel; then adjust the meter wheel and the parallel belt reasonably. The position of the cylinder and the pressure point is such that the cut wire is properly clamped between the two traction wheels and the two meter wheels. At this time, the wire is pressed without deformation, and the meter wheel does not slip. Then, according to the requirements of the wire harness processing, the length of the cutting line, the number of rolling, and the number of the strips are respectively set; then the take-off motor, the line motor, the main motor, and the slow-speed trial cutting wire are respectively turned on; then the screen of the cutting machine is used to appropriately adjust the cutting Line length, can speed up the cutting speed after the required range; after use, turn off the computer stripping machine switch, cut off the power.

Notes on the use of computer cutting machine: 1. The computer cutting machine must be operated by trained personnel. The operator should be familiar with the performance and structure of the machine and know how to deal with mechanical failure. 2, the new machine has a running-in period, in the first few months, the cutting machine should not cut the line too fast. 3. The cutting machine should be placed in a stable place during operation to prevent damage during the operation. 4. Change tools, measuring tools, etc. must be stopped. 5. Do not touch the transmission parts during the production of the cutting machine to avoid injury. 6. The cutting machine should be suspended when leaving during the operation. 7. When the fault occurs, stop the machine immediately, unplug the power if necessary, and continue production after the fault is cleared. 8, the machine must not be overloaded.

The above is about the specific operation steps of the computer cutting machine and related notes, to understand the operating rules of the computer cutting machine, the operation of the computer cutting machine can be said to be foolproof.