With the rapid development of the Internet, High-speed stranded cable was sold throughout the country, gradually replacing old-fashioned stranding equipment. Compared with the existing high-speed stranding machine, the existing high-speed stranding machine not only has the characteristics of high speed, low noise, simple operation, perfect detection and alarm system, but also the product quality is more round and the stranding distance is more stable. No matter how good the equipment is, there are inevitable failures. As the production of the stranding machine increased, various failures occurred. This article briefly describes several common faults in high-speed stranding machines: tripping, broken wires, spikes, noise, and burns. Jumping stocks: Also known as back stocks and stocks, the reasons are:

First, the tension is uneven, elastic, elastic, and the tight iron core will go too far, causing back stocks.

Second, the mold hole type is too large to properly adjust the tension.

Three, the mold position is not suitable, the twist angle is unreasonable, and fourth, the pitch is large.

      Single strander is made up of 19 shares or more. Since the strands have no direction difference and can only be twisted in the same direction, the combination of the core wires is irregular. At present, manufacturers use double pitch stranding systems. Therefore, the twisting phenomenon of more than 19 strands is more serious than the stranding machine.

Exclusion method:

First, it is a perfect wire stranding device,

Second, using advanced single-line tension adjuster to make each single wire tension Can be adjusted and controlled.

Three, the hoist of the hoist can reach the aquatic products of the steel strand.

Four, using the method of overmolding, can meet the requirements of use.

Five, the pitch ratio should be adjusted appropriately.