Blocking Machine When the foundation is installed and is to be solidified, install the power wiring.

     After all the installations are in place, the rotating parts should be lubricated and the motor started. After running for one hour at low speed, check if the fasteners are loose and tighten if loose. After all inspections are completed, run at high speed and check for no-load operation.

This machine can twist 19 strands of copper cord and remove two transmission parts to produce 7 strands of copper cord. It can also rewind 12 strands separately.

     Install the reel, pull the wire onto the tensioning wheel, close the protective net, start the motor, and gradually adjust the speed. When the wire core is first screwed, check the tension of the elastic friction belt installed on the friction wheel of the wire plate. The tension of the friction belt is too large, causing the steel wire to break. The tension of the friction belt is too small. The wires in the reels are easy to reverse after stopping. Therefore, before and during use, the condition of the reel rotation and shutdown should be checked.

When the coil is full, stop the main engine, rotate the drive connection to the lift position, start lifting and twisting, lower it, take out the reel, install the empty disc, and then rise to the drive connection position. In the process of loading and unloading the empty plate, it must be noted that the loading and unloading position of the drive connection is in place.

      Each time the coil is started or replaced, the governor must be reset to zero to prevent direct damage to the governor, stop the host without shutting down the network, and prevent The accident occurred.