Belt Machine Safe operation of milling machines in the production hall Maintenance procedures

1, work clothes should be worn during work, and gloves should not be used to operate the machine.

2. Install the arbor, bracket, washer, indexing head, vise, knife hole, etc., the contact surface should be wiped clean. 3. The rough surface of the workpiece must not be directly pressed on the work surface or the jaws, and if necessary, padded.

4. When replacing the tool holder, cutter head, vertical milling head and milling cutter, stop. After the lever screw is loose, take care to avoid picking up the hand or damage the machine. 5, ** When milling vertical feed, the workpiece is loaded with a certain distance from the workbench.

6. When performing down-cutting, be sure to clear the gap between the lead screw and the nut to prevent the cutter from being damaged. 7. The knife bar washer can not be used for other pads. Check the parallel wire winding machine before use. 8. When driving fast, the handwheel must be disconnected from the rotating shaft to prevent the handwheel from rotating and injuring people.

9. When cutting high-speed milling, it is necessary to prevent iron filings from injuring people, and it is not allowed to brake hard to prevent the shaft from being cut.

10. The longitudinal, lateral and vertical movement of the milling machine should be consistent with the direction of the operating handle, otherwise it will not work. When the milling machine is working, the vertical, horizontal and vertical automatic cutting can only select one direction, and the safety bezel wire forming machine in all directions cannot be removed at will. 11. After the work is completed, the chips should be removed, the machine tool should be wiped, the lubricant should be added, and the power should be turned off.